Enclosure case for NodeMCU ESP8266 and 0.96" OLED Display
A small 3D Printed enclosure case for an ESP8266 and 0.96" 128x64 pixel display.
This case is designed to fit the original NodeMCU ESP8266 development board (0.9" or 22.86mm width) and other Amica clones.
This case will not fit the larger LoLin NodeMCU (1.1" or 27.94mm width) and it's clones.
Please check your board dimensions before printing to make sure it will fit.
No supports required for printing. Both parts should be printed flat on the bed. Since the walls are thin, I recommend at least 30% infill.
No comments so far.
Log in to post a comment.
Free design files:
This work is licensed under the terms of the Creative Commons: Attribution.
Get it from our Makers:
Open a request to get offers from Makers who can fabricate this design for youOpen a request