Ruichen (Posted 4 years ago)

FOUR quarter-inch thick plates with 1/4" holes. Please refer to drawing. LMK if you have any questions.
Steel, no surface finish needed.

Sam-sam (Posted 4 years ago)

1x support with v-groove per attached CAD file.
Please let me know if you have any questions.

Gullslo (Posted 4 years ago)

Hi there,
I am looking to make (5) small aluminium parts for my project.
Material: Aluminium, Surface Finish: No special requirements, Tolerance: 0.1mm.
Need them ASAP if possible. TY!

davochino (Posted 4 years ago, last edited 4 years ago)

12x cylindrical pins.
Dimensions are indicated on the drawing.
Tolerances 0.001"
Parts needed within 2 weeks.

Vic Schaefer (Posted 4 years ago, last edited 4 years ago)

See drawing for all details. Ping me if you have any questions.

Koss78 (Posted 4 years ago)

Making a personalised pi cases. Please see STL file for dimensions.
Material: Aluminium
Surface finish: polished for the outer surface so that there is no machining mark (I will do some engraving on...

RohanG (Posted 4 years ago, last edited 4 years ago)

I would like a small steel part made for a motor. Dimensions as shown in drawing attached.
tolerance requried ~1/64". No special finish needed.
Let me know if you have any questions.
Thanks!
Rohan...

Michael Robel (Posted 4 years ago, last edited 4 years ago)

Hello all, I need 12 cylindrical spacers in aluminum.

Michael Robel (Posted 4 years ago, last edited 4 years ago)

(1x) Simple stainless steel bracket with M5 hole on bottom and and two 15mm holes on the sides. Will be used to fix GPS on my boat.